OSP.com performs fiber blowing and cable placement for OSP and ISP networks where controlled installation methods are required to protect fiber integrity and support future expansion.

Scope of Work

• Fiber blowing in microduct and bundled microduct systems
• Traditional fiber pulling in conduit systems
• Long-distance and segmented route placement
• Placement of single-mode and multi-mode fiber

Fiber Blowing – Technical Execution

• Blowing method selected based on duct diameter, route length, and cable design
• Air pressure, flow rate, and fiber feed controlled within manufacturer limits
• Installation coordinated to maintain fiber integrity and efficiency

Cable Pulling – Technical Execution

• Pulling tension monitored to remain within manufacturer limits
• Bend radius maintained at access points and transitions
• Cable lubricants applied as specified
• Intermediate pull points used where required

Pre-Installation Verification

• Duct continuity and obstruction checks
• Confirmation of pull tape or mule tape
• Verification of access points, sweeps, and handholes

Quality Control & Deliverables

• Monitoring of installation parameters
• Visual inspection at entry and exit points
• Field redlines for as-built documentation
• Installation records supporting acceptance and turnover

Applicable Standards

• Manufacturer installation guidelines
• TIA-568 and TIA-569 (as applicable)
• Project-specific specifications and drawings